PH21-230-800-150L
启动方式：预热启动
E-mail: Chenxh@Zigykj.com
Phone:(+86)13683140930
WhatsApp: +86 13396691363
Product Description
InputCharacteristic输入特性
| Input Voltage 输入电压 | 230V | |||
| Input Voltage Range输入电压范围 | 198V ~ 264V | |||
| Power Line Frequency工作频率 | 50/60Hz | |||
| Maximum Line Current输入最大电流 | 0.72A@230V | |||
| Input Power输入功率 | 165W@230V | |||
| Input Power Factor (PF)输入功率因数 | ≧0.99@165W | |||
| In Rush Current开机冲击电流 | 40A | |||
| Surge Protection突波保护 | Yes | |||
| Current Protection过流保护 | Yes | |||
OutputCharacteristic输出特性
| Lamp Types灯管型号 | GPH1554T5HO,GHO64T5,TUV64T5HO,GPHO1148T5 GHO36T5,TUV36T5HOGPHO893T5,GPHO846T5 TUVPL-95WHO,TUV75WHO,TL100W | |||
| Number of Lamps灯管数量 | 1 | |||
| Lamp Current [mA]灯管电流 | 800(720-880) | |||
| Ignition Method启动方式 | Preheat Start | |||
| Signal feedback信号反馈 | 5VDC/10mA--(UV灯亮--5VDC ，UV灯灭---0VDC)或开关量 | |||
| Open Circuit Protection开路保护 | Yes | |||
| Type CC | Yes | |||
| RFI/EMC | EN61347-1,EN61347-2-3 | |||
EnvironmentalRequirements环境要求
| Max. Case Hot Spot Temperature外壳最大温度(°C） | 70 | |||
| Min. Lamp Starting Temperature最小启动温度(°C） | -10 | |||
| Min. operating Temperature工作最低温度(°C） | -10 | |||
| Max. Ambient Temperature最大工作环境温度(°C） | 45 | |||
| Humidity湿度 | 5%-85%/IP62 | |||
| Warranty质保寿命 | 2 Years@Tc,70°Cmax | |||
MechanicalRequirements机械要求
| Weight 重量 | TBD | |||
| _Length w/Mount外壳长度 | 215mm | |||
| Diatance between Mounting Holes 安装孔 | 211mm | |||
| _Width外壳宽度 | 44mm | |||
| _Height外壳高度 | 30mm | |||
| _Input(mm) 引线 | WIRE UL1015 20AWG 多芯黑/白色 105℃ 600VAC 1*430mm | |||
| _Output(mm) 输出引线 | WIRE UL1015 20AWG 多芯红/黄色 105℃ 600VAC 2*650mm | |||
| 信号反馈引线 | WIRE UL1007 24AWG 多芯红/黑色 80℃ 300VAC 1*650mm | |||
| Potting | 黑胶 | |||
SketchMap示意图
Caution注意事项
The power supply must be cutoff when installing or replacing ballast安装与更换镇流器，必须先切断电源
Ballast housing must be grounded safely镇流器外壳必须安全接大地
"The length of the connecting line between the ballast and the lamp tube shall not exceed 10m, and thecross-sectional area of the line shall not be less than 0.5mm²镇流器与灯管的连接线长不能超过10m,并且线的截面积不能小于0.5mm平方"
You May Like
Qualification certificate
Get A Quote
告诉我们更多信息，以便我们为您联系合适的人选。
成都市温江区海达路88号1栋4层2区 金地威新温江智造园港 